"Glass Brackets & Glass Bracket Clamps" Frequently Asked Questions
To ensure that your glass panels don’t slip through the glass brackets, make sure to check the thickness of your panels and buy the correct glass bracket clamps to fit your panels. Our brackets come in a range of sizes from 6mm to 10mm, so make sure you buy the right one to match your panels.
The most important thing to remember when attaching your glass clamps is to evenly distribute the weight of the glass throughout the post. For all of our panels, we recommend using 2 glass bracket clamps to ensure that there’s enough support. It’s advisable to attach a clamp at the top and bottom of each panel and evenly distribute the weight by making the clamp positioning symmetrical.
As mentioned above, we recommend using 2 glass brackets per glass panel. This ensures that there are enough clamps to support the weight of the glass. Make sure to place them evenly and not at an angle to ensure that they’re evenly supported, as this will keep them sturdy and safe for years to come.
You can use blocks at the bottom of the railing to hold the glass panel in place, this will allow you to tighten the clamps without worrying about holding it in position. Separate the glass brackets and attach the first side of each to the post, you can then place the glass panel against the inside of these clamps. Once in place, simply screw the other side of the glass bracket into the attached side with the panel in between.
A glass balustrade, or glass panels, will use glass brackets or glass bracket clamps to secure them in place. These clamps are evenly distributed around the panel and tightened to hold it in position. Correctly positioning the brackets around your panel is essential for an appealing and secure balustrade, so it’s important to get right.
Glass bracket clamps can come in a range of materials. At Jackson Woodturners, our range includes black nickel, brushed nickel, and chrome in a wide range of sizes and styles. Get in touch with a member of our expert team for help with making the right choice.
You should aim to get the clamps as tight as you can while tightening the screws by hand. Any more and you may have issues removing the screws in future, and you can damage the rubber seal that holds onto the glass. Any less than this and you may risk allowing the glass to slip through the bracket.
It’s also a good idea to gradually tighten each bracket one turn at a time. This avoids bending or cracking the glass like you could if you tightened one clamp all the way before the others.
It’s also a good idea to gradually tighten each bracket one turn at a time. This avoids bending or cracking the glass like you could if you tightened one clamp all the way before the others.